Custom designed 3D printed Holster/mount for the Anytone BT-01 Mic/Remote

 The BT-01 is very handy but does not come with any kind of mount other than a belt clip. Since most use will be mobile, I've designed a holster/mount and made it available for purchase. 

It is available for order here

 

  • 3D printed in Black or Grey using tough PETG which can withstand parked car temperatures
  • Engineered design with radiused edges and corners printed extra thick for durability
  • Countersunk holes to mount to console or panels in addition to allowing the use of widely available AMPS pattern mounts for RAM, Garmin 17mm, or similar
  • Can be on either a horizontal or vertical surface
  • Recessed pocket to retain the mic via the clip if desired
  • Usable with or without Cat5 cable

Also available in White, satin Silver, Satin Red, and Satin Green by special request

Anytone BT-01 Holster Front

Purchase via paypal:

  • One mount for $16
  • Two for $22
  • Three for $28
  • Free USPS shipping in US for 1-4 mounts
  • Contact via email for larger quantities

Note: Ram/Garmin mounts and adapters are shown for illustration and are not included in the purchase. Only the 3d printed mount is included.

Black Quantity
Anytone BT-01 Holster Front
Grey Quantity
Anytone BT-01 Holster Front

Anytone BT-01 Holster Front Anytone BT-01 Holster Front Anytone BT-01 Holster Front Anytone BT-01 Holster Front Anytone BT-01 Holster Front 
Anytone BT-01 RAM example Anytone BT-01 RAM example Anytone BT-01 garmin example Anytone BT-01 garmin example